Yamaha Audio Mixer
Digital TF5
MFR# TF5
BLK# 034-0414
in-Store Price: 4.951,80€ + VAT
Online Price: 4.753,72€ + VAT
- Desktop 48-CH Digital Audio Mixer
- 32x XLR/Jack 6.3mm Combo MIC/Line IN
- 8x 3-pin XLR Omni outputs
- 2x RCA Line inputs
- 33 motor faders (32 channels + 1 master)
- 48 input mixing channels (40 mono + 2 stereo + 2 return)
- 20 Aux (8 mono + 6 stereo) + Stereo + Sub buses
- 8 DCA groups with Roll-out
- 32 analog XLR/TRS combo mic/line inputs + 2 analog RCA pin stereo line inputs
- 16 analog XLR outputs
- 34 x 34 digital record/playback channels via USB 2.0 + 2 x 2 via a USB storage device
- 1 expansion slot for NY64-D audio interface card
| Fader Configuration | 32 + 1 (Master) | |
|---|---|---|
| Mixing Capacity | Input Channels | 48 (40 mono + 2 stereo + 2 return) |
| Aux Buses | 20 (8 mono + 6 stereo) | |
| Stereo Buses | 1 | |
| Sub Buses | 1 | |
| Input channel functions | 8 DCA Groups | |
| I/O | Inputs | 32 mic/line (XLR/TRS combo) + 2 stereo line (RCA pin) |
| Outputs | 16 (XLR) | |
| Expansion slots | 1 | |
| On-board processors | DSP | 8 Effects + 10 GEQ |
| USB | 34x34 USB Audio Interface, 2-track recording via USB Storage Device | |
General specifications
| Sampling frequency rate | Internal | 48 kHz |
|---|---|---|
| Signal delay | Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz | |
| Fader | 100 mm motorized, Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders | |
| Total harmonic distortion | Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 , INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz) | |
| Frequency response | +0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT | |
| Dynamic range | 110 dB typ., DA Converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min. | |
| Hum & noise level | Equivalent input noise | –128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter) |
| Residual output noise | –85 dBu, ST master off (Measured with an A-Weight filter) | |
| Crosstalk | –100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min. | |
| Power requirements | 100–240 V 50/60 Hz | |
| Power consumption | 120 W | |
| Dimensions | W | 866 mm (34.1in) |
| H | 225 mm (8.9in) | |
| D | 599 mm (23.6in) | |
| Net weight | 20.0 kg (44.1lb) | |
| Accessories | Quick Guide, Power Cord, CUBASE AI download information | |
| Options | Expansion Card, Foot Switch (FC5) | |
| Others | Operating temperature range: 0–40 °C, Storage temperature range: -20–60 °C | |
Analog input characteristics
| Input Terminals | GAIN | Load Impedance |
For Use With Nominal |
Input Level | Connector | balanced / Unbalanced |
||
|---|---|---|---|---|---|---|---|---|
| Sensitivity*1 | Nominal | Max. before clip | ||||||
| INPUT1-32 | +66dB | 7.5KΩ | 50-600Ω Mics or 600 Ω Lines |
-82dBu (61.6 V) | -62dBu (0.616mV) | -42dBu (6.16mV) | Combo Jack (XLR-3-31 type *2 or TRS phone *3) |
Balanced |
| -6dB | -10dBu (245mV) | +10dBu (2.45V) | +30dBu (24.5V) | |||||
| ST IN 1,2 | — | 10kΩ | 600 Ω Lines | -30dBV (31.6 V) | -10dBV (316mV) | +10dBV (3.16V) | RCA Pin Jack | Unbalanced |
*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
Analog output characteristics
| Output Terminals | Source Impedance |
For Use With Nominal |
Output Level | Connector | balanced / Unbalanced |
|
|---|---|---|---|---|---|---|
| Nominal | Max. before clip | |||||
| OMNI OUT 1-16 | 75 Ω | 600Ω Lines | +4dBu (1.23 V) | +24dBu (12.3 V) | XLR-3-32 type *1 | Balanced |
| PHONES *3 | 100 Ω | 40Ω Phones | 3mW | 75mW | Stereo Phone Jack (TRS) *2 | Unbalanced |
*1.1: GND,2: HOT, 3: COLD
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.
Digital input/output specifications
| Terminals | Format | Data length | Audio | Connector |
|---|---|---|---|---|
| USB (TO HOST) | USB | 24bit | 34ch input / 34ch output, PCM | USB (B type) |
| iPad | USB | — | Playback: MP3 or WAV file data / Record: WAV file data | USB (A type) |
Control I/O specifications
| Terminals | Format | Level | Connector |
|---|---|---|---|
| NETWORK | IEEE802.3 | 10BASE-T/100Base-TX | RJ-45 |
| FOOT SW | — | — | TS Phone |
STATUS
- Status
- New
- Availability
- 15 Business Days
- Audio Mixer Type
-
Desktop Audio Mixer
- Digital/Analog
-
Digital Mixer
- No. of Channels
-
48
GENERAL FEATURES
- Phantom Power 48V
-
Yes
- Digital Effects
-
Yes
- No. of Digital Effects
-
8 Effects + 10 GEQ
- Equalizer
-
Yes
- Group outputs
-
Yes
- No. of Group outputs
-
8 DCA Groups
- AUX Outputs
-
Yes
- No. of AUX outputs
-
20 (8 mono + 6 stereo)
- Busses
-
Yes
- No. of Busses
-
22 (8 mono + 6 stereo + 1 Sub bus + 1 Stereo Bus)
- PRE Fader
-
Yes
- Audio Meters
-
Yes
- Peak indicator
-
Yes
- Mount
-
Desktop
- Distortion
-
Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 , INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz)
- Frequency Response
-
+0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT
- Input Noise
-
–128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter)
- Output Noise
-
–85 dBu, ST master off (Measured with an A-Weight filter)
- High Pass Filter (HPF)
-
Yes
MORE SPECIFICATIONS
- Extras
-
34x34 USB Audio Interface, 2-track recording via USB Storage Device.
32+1(master) 100 mm motorized faders.
Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders
- Power
-
AC 220V
- Power Consumption
-
120Watt (220V/0.54A)
- Country of Origin
-
Japan
- Warranty
- 2 Years
PHYSICAL
- Total Dimensions (WxHxD)
- 86.6 x 59.9 x 22.5 cm
- Total Weight
- 20 kg
- Mixer
- Power Cord
- Manual
-
Pdf not available.
Video not available.
